CNC Stepper Driver Leadshine M542 4.2A DC 18V - 50V
Introduction
The M542 V2.0 is a high performance microstepping driver based on pure-sinusoidal current control technology. Owing to the above technology and the Self-adjustment technology (self-adjust current control parameters) according to different motors, the driven motors can run with smaller noise, lower heating, smoother movement and have better performances at higher speed than most of the drivers in the markets. It is suitable for driving 2-phase and 4-phase hybrid stepping motors.
Features
-
High performance, cost-effective;
-
Automatic idle-current reduction;
-
Supply voltage up to +50V DC;
-
15 selectable resolutions in decimal and binary,up to 25,600 steps/rev ;
-
Output current up to 4.2A;
-
Self-adjustment technology;
-
Suitable for 2-phase and 4-phase motors ;
-
Pure-sinusoidal current control technology;
-
Support PUL/DIR and CW/CCW modes ;
-
Pulse input frequency up to 300 KHz;
-
Short-voltage, over-voltage, over-current protections ;
-
TTL compatible and optically isolated input.
Applications
Suitable for a wide range of stepping motors, from NEMA size 17 to 34. It can be used in various kinds of machines, such as X-Y tables, engraving machines, labeling machines, laser cutters, pick-place devices, and so on. Particularly adapt to the applications desired with low noise, low heating, high speed and high precision.
Applicable motor type:
(1) 57,86 two-phase hybrid stepping motor
(2) operating current: 4.2A
(3) Working voltage: DC18V-DC50V
ราคา 3150 บาท